If you select [Prohibit], the machine stops during startup when a firmware structure change is detected
and a message requesting administrator login is displayed. After the machine administrator logs in,
the machine finishes startup with the updated firmware.
The administrator can confirm if the updated structure change is permissible or not by checking the
firmware version displayed on the control panel screen. If the firmware structure change is not
permissible, contact your service representative before logging in.
When Change Firmware Structure is set to [Prohibit], administrator authentication must be enabled.
After [Prohibit] is specified, turn off administrator authentication once, and the next time administrator
authentication is specified, the setting will return to the default, [Do not Prohibit].
If you select [Do not Prohibit], firmware structure change detection is disabled.
• Prohibit
• Do not Prohibit
• p.125 "Protecting the Address Book"
• p.115 "Preventing Data Leaks Due to Unauthorized Transmission"
• p.179 "Setting the SSL / TLS Encryption Mode"
8. Specifying the Extended Security Functions
214
To Next Page
Loading...
Need help?
General Specifications
