Facsimile Features
144
4
E Enter a horizontal size using the number keys.
Each time you press [mm] or [inch], the units switch between "mm" and "inch".
If you enter a length and press [mm] or [inch], the length is converted automat-
ically according to the unit (fractions are rounded off). For example, when
you enter {2}, {2}, and {0} in millimeters and change to "inch", the length "8.7
inch" is shown on the display. If you press [mm] or [inch] again, "221 mm" is
displayed.
If you make a mistake, press [Clear] or the {Clear/Stop} key, and then try again.
To cancel a scan size, press [Cancel].
F Select a vertical size, and then press [OK].
The displayed vertical size differs depending on the selected unit. When [mm]
is selected, [Auto Detect], [210 mm (A4)], [257 mm (B4 JIS)], [297 mm (A3)], [216 mm
(8 1/2)], and [279 mm (11)] are shown. When [inch] is selected, [Auto Detect], [8.3
inch (A4)], [10.1 inch (B4 JIS)], [11.7 inch (A3)], [8.5 inch], and [11.0 inch] are shown.
To cancel a scan size, press [Cancel].
G Press [Exit].
H Press the {User Tools/Counter} key.
To Next Page
Loading...
