Forwarding
151
4
Programming an End Receiver
Important
❒ One end receiver can be registered for each special sender. To register two or
more end receivers, use group destination. However, a maximum of 500 des-
tinations can be specified in a group.
A Press [Facsimile Features].
B Press [Reception Settings].
C Press [Forwarding].
D Press [On].
If there is an End Receiver already programmed, a receiver name is shown. If
you want to change the receiver, press [Receiver] and proceed to step
E
.
To cancel Forwarding, press [Off]and proceed to step
F
.
To Next Page
Loading...
