Page Numbering
This section describes the user tools in the Page Numbering menu under Stamp.
Stamp Format
You can select the page number format given priority when [Page Numbering] is pressed.
Default: [P1,P2...]
Font
You can select the font in Page Numbering mode.
Default: [Font 1]
Size
You can set the size of the stamp printed in Page Numbering mode.
Default: [Auto]
Duplex Back Page Stamping Position
You can set the position of the duplex back page number printed in Duplex mode.
Default: [Opposite Position]
Page Numbering in Combine
You can set page numbering when using the Combine function and the Page Numbering function
together.
Default: [Per Original]
Stamp on Designating Slip Sheet
You can select whether or not to print the page number onto slip sheets when using the Designate
function set to “Copy” and the Page Numbering function together.
Default: [Off]
Stamp Position
Specify how each of stamps is printed.
• Stamp Position
Specify where to print the stamp.
Default for the patterns of “P1,P2...”, “1/5,2/5...”, “P.1,P.2...”, and “1,2...”: [Top Right]
Default for the patterns of “-1-,-2-...” and “1-1,1-2...”: [Bottom Center]
• Adjust Stamp Position
You can adjust the position of the stamp within the available ranges shown below.
“Top Left” T/B: 0.1 5.7 inches, L/R: 0.1 5.7 inches
“Top Center” T/B: 0.1 5.7 inches, L/R: 2.8 2.8 inches
“Top Right” T/B: 0.1 5.7 inches, L/R: 0.1 5.7 inches
Stamp
233
To Next Page
Loading...
Need help?
General
