Combined Copying
This section describes how to make combined copies.
• When placing originals on the exposure glass, start with the first page to be copied. When placing
originals in the ADF, set the first page on top.
• When placing originals on the exposure glass or in the ADF using the Batch function, press the [ ]
key after all the originals have been scanned.
• If you selected [2 Sided] for Original or [Combine 2 Sides] for Copy, you can change the orientation.
See “Originals and Copy Orientation”.
• You can change the initial settings for 1-Sided Combine or 2-Sided Combine under Edit in User Tools.
For details, see “Edit”.
• In this mode, the machine selects the reproduction ratio automatically. This reproduction ratio depends
on copy paper sizes and the number of originals.
• The machine selects reproduction ratios of between 25 and 400%.
• If the calculated ratio is under the minimum ratio, it is automatically adjusted to within available range.
However, with some ratios, parts of the image might not be copied.
• If the orientation of originals is different from that of the copy paper, the machine will automatically
rotate the image by 90 degrees to make copies properly.
• If the number of originals placed is less than the number specified for combining, the last page segment
is left blank as shown.
• p.65 "Originals and Copy Orientation"
• p.225 "Edit"
One-Sided Combine
Combine several pages onto one side of a sheet.
There are six types of One-Sided Combine.
2. Basic Copying
66
To Next Page
Loading...
Need help?
General
