Ricoh Aficio MP C4501 - Page 238

Staple Position
Specify which staple type has priority to be shown on the initial display.
• When Finisher SR790 is installed:
Default for “Staple Position 1”: [Staple: Top 1]
Default for “Staple Position 2”: [Staple: Bottom 1]
Default for “Staple Position 3”: [Staple: Left 2]
Default for “Staple Position 4”: [Staple: Top 2]
• When Finisher SR3050 is installed: (Type 1 and 2)
Default for “Staple Position 1”: [Staple: Slant]
Default for “Staple Position 2”: [Staple: Bottom Slant]
Default for “Staple Position 3”: [Staple: Left 2]
Default for “Staple Position 4”: [Staple: Top 2]
• When Booklet Finisher SR3000 is installed: (Type 1 and 2)
Default for “Staple Position 1”: [Staple: Top 1]
Default for “Staple Position 2”: [Staple: Center]
Default for “Staple Position 3”: [Staple: Left 2]
Default for “Staple Position 4”: [Staple: Top 2]
• When Finisher SR3030 is installed: (Type 3 and 4)
Default for “Staple Position 1”: [Staple: Top 1]
Default for “Staple Position 2”: [Staple: Slant]
Default for “Staple Position 3”: [Staple: Left 2]
Default for “Staple Position 4”: [Staple: Top 2]
• When Booklet Finisher SR3020 is installed: (Type 3 and 4)
Default for “Staple Position 1”: [Staple: Top 1]
Default for “Staple Position 2”: [Staple: Center]
Default for “Staple Position 3”: [Staple: Left 2]
Default for “Staple Position 4”: [Staple: Top 2]
Punch Type
Specify which punch type has priority to be shown on the initial display.
Default for “Punch Type 1”: [Punch: 3 Holes Left]
Default for “Punch Type 2”: [Punch: 3 Holes Top]
6. Copier and Document Server Features
236
6