• Cancels the stapling job
• To specify Left 2, Top 2, or Slant together with 2 Originals or 8 Originals of Combine 1 Side, or 4
Originals or 16 Originals of Combine 2 Sides: specify paper for orientation originals and specify
paper for orientation originals.
• To specify Left 2, Top 2, or Slant together with Double Copies: specify paper for orientation
originals and specify paper for orientation originals.
• Even if you place different size originals in the ADF, appropriate size of copy paper can be
automatically selected and stapled using the Mixed Sizes mode and Auto Paper Select function. Load
the paper you want to use in the paper trays beforehand. Paper sizes that can be stapled when using
the Mixed Sizes mode are as follows:
• A3 and A4
• B4 JIS and B5 JIS
• 11 × 17 and 8
1
/
2
× 11
• 8K and 16K
• When stapling B4 JIS , 8
1
/
2
× 14 or larger paper sizes, be sure to extend the paper support
plate of the finisher tray.
• You cannot change stapling positions during copying.
• When the original image is rotated, the staple orientation changes by 90 degrees.
• The maximum original image size that can be rotated is A4.
• When using Slant, Left 2, or Top 2 with the Combine, Double Copies or Auto Reduce / Enlarge
function, "Orig. and paper orientation mismatched for Staple mode. Cancel Staple mode or change
paper orientation in tray." message may appear depending on the orientation of originals and paper
you placed. In this case, change the paper orientation.
• When Top or Bottom is selected and the paper with the same orientation as the original is not loaded,
the image is rotated and the paper with the same size and the different orientation is selected.
• When Left 2, or Top 2 is selected, the following settings are useful to rotate images appropriately:
• Auto Reduce / Enlarge or Auto Paper Select
• Replace Auto Tray Switching with With Image Rotation in User Tools.
• If you select Center with the booklet finisher, the machine staples and folds the paper in the center,
then delivers the paper folded.
• If you select Center for the Magazine function, the machine staples the paper, and folds it like a book,
then delivers the paper folded.
• When the number of copies exceeds tray capacity, copying stops. If this happens, remove the copies
from the finisher tray to resume copying.
• Depending on the settings for the Staple, you may not be able to use the Rotate Copy function.
Finishing
89
To Next Page
Loading...
Need help?
General
