No. Message Action
21
Cannot recover error
page(s) / FormFeed to print
remaining
An unprinted page still remains after recovery from a paper
jam or another problem and re-starting printing. Press [Form
Feed] to eject the sheet. Press [Job Reset] to delete any data
remaining from the previous job.
22
Top Cover is open /Close Top
Cover
The top cover is open. Check and close the top cover.
25
Cannot use High Temp./
Power Off On
Machine temperature is high and has exceeded the high
temperature range for normal operation. Re-locate the
machine to a location within the temperature range and wait
for the machine to acquire room temperature.
26
Cannot use Low Temp./Power
Off On
Machine temperature is low and has fallen below the low
temperature range for normal operation. Re-locate the
machine to a location within the temperature range and wait
for the machine to acquire room temperature.
27
Ink depleted / Used Ink
Crtrdge
A used print cartridge has been installed. Install a new print
cartridge.
28
Used Ink Collect Unit is set/
Replace Ink Collector Unit
A used ink collector unit has been installed. Install a new ink
collector unit.
29 Reset Bypass Tray correctly
Multi bypass tray unit is not set correctly. Make sure that the
multi bypass tray is set correctly.
30
Load Paper:Tray 1
--or--
Load Paper:Tray #/ or Form
Feed
--or--
Load Ppr.:Bypass / or Form
Feed
Paper has run out in the selected tray. Load paper in the
selected tray. Or, press [Form Feed] and select another tray
holding paper for printing. Press [Job Reset] to delete any
data remaining from the previous job. The tray numbers
depend on the machine model.
•
The trays are designated Tray 1, 2 or Bypass.
Error Codes
203
To Next Page
Loading...
