Details The relay sensor of Tray 2 went ON while the jammed paper was being removed.
Action 1
• Remove the rear unit of Tray 2 and remove any paper inside the tray.
• Make sure that the paper is stacked correctly in Tray 2 and Tray 3.
Action 2
•
Remove the rear unit of Tray 2 and remove any remaining paper.
• Re-install the rear unit of Tray 2.
•
Remove Tray 2 and remove any jammed paper.
• Re-install the tray correctly.
Jam 23 Not Used
Jam 24 Not Used
Jam 25 Not Used
Jam 26 Not Used
Jammed paper location
A: 2nd registration sensor (2nd) D: Tray 2
B: Output tray E: Tray 2 relay sensor (T-2)
Error Codes
107
To Next Page
Loading...
