Action 2
• Replace inverter guide.
• Replace trailing edge sensor.
• Replace CTL board.
Jam 6 Paper Feed Jam (Bypass Tray)
Message
Paper Misfeed
Remove Bypass Tray and reset the paper. If there is any paper that is jammed remove
it.
Cause
• Paper slippage
•
Paper not loaded correctly
Details
The registration sensor did not detect the leading edge of the paper fed from the
bypass tray within the prescribed time .
Action 1
•
Remove bypass tray
• Load paper correctly.
• Check inside the paper for jammed paper or paper scraps.
Action 2
•
Clean transport belt.
•
Replace Registration Sensors 1, 2.
• Replace Multi Bypass Tray.
• Replace the printer.
Jam 7 Transport Jam (Tray 2: PFU)
Message
Paper Misfeeed
Press the Form Feed button.
Cause Paper longer than the paper selected in printer driver was loaded.
Details
When paper was fed from Tray 2 the paper fed but the paper failed to leave the
trailing edge sensor within the prescribed time.
Action 1
• Check the size of the paper loaded in the PFU
• Make sure that the size of the paper selected in the printer driver matches the
size of the paper loaded in the tray.
Error Codes
227
To Next Page
Loading...
