No. Message Action
25
Cannot use High Temp./
Power Off On
Machine temperature is high and has exceeded the high
temperature range for normal operation. Re-locate the
machine to a location within the temperature range and wait
for the machine to acquire room temperature.
26
Cannot use Low Temp./Power
Off On
Machine temperature is low and has fallen below the low
temperature range for normal operation. Re-locate the
machine to a location within the temperature range and wait
for the machine to acquire room temperature.
27
Ink depleted / Used Ink
Crtrdge
A used print cartridge has been installed. Install a new print
cartridge.
28
Used Ink Collect Unit is set/
Replace Ink Collector Unit
A used ink collector unit has been installed. Install a new ink
collector unit.
29 Reset Bypass Tray correctly
Multi bypass tray unit is not set correctly. Make sure that the
multi bypass tray is set correctly.
30
Load Paper:Tray 1
--or--
Load Paper:Tray #/ or Form
Feed
--or--
Load Ppr.:Bypass / or Form
Feed
Paper has run out in the selected tray. Load paper in the
selected tray. Or, press [Form Feed] and select another tray
holding paper for printing. Press [Job Reset] to delete any
data remaining from the previous job. The tray numbers
depend on the machine model.
•
The trays are designated Tray 1, 2 or Bypass.
31
Change Setting Tray # /
(paper size) (paper type)
The type and/or size of paper in the selected tray do not
match the type and/or size of the paper selected for the job.
Replace the paper in the tray with paper of the size/type
selected for the job, and then change the paper size/type
on the operation panel. Or, press [Form Feed] and select
another tray holding paper of the size/type selected for
printing. Press [Job Reset] to delete any data remaining from
the previous job. The tray numbers depend on the machine
model.
• The trays are designated Tray 1, 2 or Bypass.
Error Codes
77
To Next Page
Loading...
