SH-P1 Training
105
Slide 105
2. Energy Saving
2.1 Overview – 1
When a printer/scanner or fax unit is installed:
No power is supplied to the printing engine, and almost none to the controller.
Sleep Mode
If no printer/scanner or fax unit is installed:
No power is supplied to the printing engine and the controller.
Auto Off Mode
DescriptionEnergy Saver Modes
Power
Consumption
Warm-up Operation Mode
Ready Mode
Off/Sleep Mode
Timer Starts
Auto Off Timer
1 – 240 min
After 240 min
from last job
Plug In
Time
Energy
Saving
When the machine is not being used, the machine enters energy saver mode to
reduce the power consumption by turning off the LCD of the operation panel and
lowering the fusing temperature.
The area shaded green in this diagram represents the amount of energy that is
saved when the timers are at the default settings. If the timers are changed, then
the energy saved will be different. For example, if the timers are all set to 240
minutes, the green area will disappear, and no energy is saved before 240
minutes expires.
Power consumption during warm-up may be much higher than shown in this
diagram.
To Next Page
Loading...
Need help?
General