Status Possible Causes, Descriptions, and Solutions
Color shift occurs. 1. Press the [Menu] key on the control panel, select
[Maintenance], and then press the [OK] key.
2. Press the [ ] or [ ] key, select [Color Dens/Reg], and then
press the [OK] key.
3. Press the [OK] key.
The whole printout is blurred. • Paper is damp. Use paper that has been stored properly.
See p.57 "Paper and Other Media".
• Perform the following operation.
1. Press the [Menu] key on the control panel, select
[Maintenance], and then press the [OK] key.
2. Press the [ ] or [ ] key and select [Anti-Humid Lvl], and
then press the [OK] key.
3. Press the [ ] or [ ] key and select [Level 2] or Level [3],
and then press the [OK] key.
• If you select [On] for [Economy Color] in the [Print Quality]
tab in the printer properties dialog box, print will be at lower
density.
See the printer driver Help.
• If the Alert indicator on the control panel lights up and the
following message appears on the display, replace the print
cartridge: "Replace Toner:"
See p.99 "Replacing the Print Cartridges".
• Condensation may have collected. If rapid change in
temperature or humidity occurs, use this printer only after it has
acclimatized.
White streaks or color streaks
appear.
• Toner is almost depleted. If an error message appears on the
control panel, replace the print cartridge of the color
indicated.
See p.99 "Replacing the Print Cartridges".
8. Troubleshooting
140
To Next Page
Loading...
Need help?
General