4. Configuration
This chapter explains supported network connections and settings for the IP addresses.
Ethernet Configuration
If connecting the printer to a network using an Ethernet cable, set the necessary settings, depending on
the network environment, on the control panel.
Web Image Monitor can be used for the settings related to the IP address.
• The following table shows the control panel settings and their default values. These items appear in
the [Network Setting] under [Host Interface] menu.
Setting Name Value
IPsec Off
IPv4 Config.
• DHCP: Active
• IP Address: XXX.XXX.XXX.XXX *
1
• Subnet Mask: XXX. XXX. XXX. XXX *
1
• Gateway Address: XXX.XXX.XXX.XXX *
1
47
To Next Page
Loading...
