2. Enter "http://(printer's address)/" in the address bar of a Web browser.
3. Enter your user name and password, and then click [Login].
For details about the login user name and password, consult your administrator.
4. Click [Configuration].
5. Click [Device Certificate] in “Security” area.
6. Check [Certificate 2] on the “Device Certificate” window, and then click [Request].
7. Enter appropriate “Common Name” and “Country Code” on “Certificate Information”
page, and then click [OK].
8. “Updating...” appears. Wait for about 2 minutes, and then click [OK].
9. Click [Details], shown in the “Device Certificate” window as the memo pad icon for
“Requesting”.
10. Select all, and then copy the entire “Text for Requested Certificate” text that is displayed in
the “Certificate Status” window.
11. Access the certificate authority server, and then obtain the CA signified certificate using the
text copied into “Text for Requested Certificate” windows.
Obtaining the certificate differs depending on the environment you want to use.
12. Click [Certificate 2] on “Device Certificate” window, and then click [Install].
13. Using a text editor, open the CA signified certificate downloaded in step 11, and then copy
over all the text.
14. In the [Install Certificate] window, paste all the text copied into the CA signified certificate.
15. Click [OK].
16. “Updating...” appears. Wait for about one or two minutes, and then click [OK].
Check that the “Device Certificate” shows “Installed”.
17. Click [Certificate 2] on “Certification”, and then click [OK].
18. Click [Logout].
19. Quit the Web browser.
• You can select any Certificate between 1 and 4 in the "Device Certificate" window. Be sure to select
the same Certificate number in both the " Device Certificate " window and the "Certification".
• If you request two certificates simultaneously, the certificate authority might not display either
certificate. Click [Cancel Request] to cancel the request.
• Click [Cancel Request] to cancel the request for the server certificate.
• If “Not found” appears after clicking [OK] in steps 8 and 16, wait one or two minutes, and then click
[Refresh].
Configuring 802.1X (WPA/WPA2)
99
To Next Page
Loading...
Need help?
General