Replacing the Transfer Unit
Replace the transfer unit if any of the following messages appear on the display:
Replacing the Transfer Unit
• The inside of this printer becomes very hot. Do not touch parts labeled " " (indicating a hot surface).
Touching these parts will result in burns.
• If the transfer unit is not installed correctly, a message appears on the control panel. Re-install the
transfer unit. If installation fails three times in a row, "SC443" appears on the control panel. If this
message appears, contact your sales or service representative.
1. Turn off the printer and unplug the power cable.
2. Holding the left and right side grips, carefully open the front cover.
To Next Page
Loading...
