Coated paper setup
Default: [Coated Paper 1]
If the print quality needs to be improved, select
[Maintenance] [General Settings] [Coated
Paper Setting] [Coated Paper 1] to [Coated
Paper 7].
When selecting the paper setting depending on the
thickness, select [Coated Paper 1] to [Coated
Paper 5]. High numbered settings allow thicker
paper to be used, but are printed more slowly.
When selecting the paper setting depending on the
type, select [Coated Paper 6], [Coated Paper 7].
High numbered settings allow thicker paper to be
used, but are printed more slowly.
Additional cautions
• Print speed is slightly slower than when using
plain paper.
• Fan the paper before loading it. When using
the bypass tray, set the paper one page at a
time if multiple sheets are fed, paper jams
occur, or you hear a strange noise.
Special paper
Special paper standard
When you cannot print successfully with other
paper type settings, set special paper.
Printer setup
Select [Paper Input] [Paper Type: (tray name)]
[Special Paper 1] to [Special Paper 3].
Printer driver setup Select [Special 1] to [Special 3] in [Paper type].
Supported paper feeding tray Any input tray can be used.
Paper capacity
Make sure paper is not stacked higher than the
upper limit mark ( ) inside the tray. When using the
bypass tray, make sure paper is not stacked higher
than the paper guides inside it.
Duplex printing Supported
5. Paper and Other Media
114