Replace the dustproof filter when the "Replace IntTrans Unit soon." message appears on the display. Replace it
with the transfer unit together.
8. Power Connector
Connect the power cable to the printer. Insert the other end into an electrical outlet.
9. Drying Heater Switch
If the paper in the paper tray is moist due to high humidity, the print quality may decrease. The drying heater
prevents moisture. If humidity is high, turn the switch on.
10. Handle
Hold this handle when you pull out the controller board.
11. Optional Gigabit Ethernet Board Slot
By removing this cover and installing the optional Gigabit Ethernet board, you can connect an Ethernet cable to
the printer.
• A hard disk is pre-installed in the HDD standard model.
1. Guide to the Printer
20
To Next Page
Loading...
