Moving the printer a short distance
• Be sure to place the printer on a smooth and stable place.
1. Be sure to check the following points:
• The power switch is turned off.
• The power cord is unplugged from the wall outlet.
• The interface cable is unplugged from the printer.
2. If any external options are attached, remove them.
See the relevant sections in this manual and reverse the steps to remove options.
3. Pull out the handle from the right side of the printer.
4. Lift the printer with four people by using the handles on both sides of the printer, and then
move it to the place where you want to install it, keeping it horizontal.
5. Return the handle you pulled out from the printer to its original position.
6. If you removed options, reattach them.
For details, see the relevant sections in this manual.
• For turning on and off the power, see "Power on and off".
11. Appendix
260
To Next Page
Loading...
Need help?
General