Insert the SD card in the appropriate slot as follows:
• Upper slot: Data overwrite security unit, camera direct print card, or NetWare card
• Lower slot: HDD encryption unit or VM card
5. Hook the SD card slot cover onto the opening, attach it flat against the controller board, and
then fasten it using the screw.
6. Plug in the power cord, and then turn on the printer.
7. See the control panel menu to confirm that the SD card was installed correctly.
• Do not touch the card while the printer is in use. The card may come loose, even if it is pushed only
slightly. The SD card slot cover must be reattached.
• You can confirm that the SD card was installed correctly by checking the control panel menu.
Depending on the SD card, certain menu items appear on the display.
• Data overwrite security unit: [Memory Erase Status] appears on the top level menu.
• HDD encryption unit: [Machine Data Encryption] appears in [Security Options].
• NetWare card: [NetWare] appears when you select [Host Interface], then [Network], and then
[Effective Protocol].
2. Installing Options
68