98
9. Roller and Sensor Inspection and Cleaning
What You Need
• Accessory hex screwdriver provided with the machine.
• A drop cloth, newspaper, or other paper to spread in front of the machine and to
cover a nearby flat surface on which you can place the removed components.
• Clean, dry cleaning cloth.
• Blower brush.
WARNING
• To prevent electrical shock, turn off the color controller on the machine
control panel, turn off the operation power switch and then the main
power switch, and then disconnect the machine from the power supply
before replacing any parts or cleaning the machine's interior.
• The fusing unit becomes extremely hot during operation; to avoid being
burned, allow the machine to cool for at least 30 minutes before you
remove or clean the fusing unit.
Preparation:
Turn the machine off. (See p.14 "Power Off Sequence".)
To Next Page
Loading...
Need help?
General
