Bit Switch 0 - Continued
BIT FUNCTION
DATA
COMMENTS
4
Short preamble (tx 0: Disabled
If this is enabled, the preamble before each protocol frame
mode)
1: Enabled
when sending to a Ricoh terminal will be reduced from 1 s to
0.2 s.
5
Indication of Fine
0: Enable
0: If the user selects Fine resolution, the machineinforms the
mode resolution in
1: Disabled
other end in the NSF signal.
NSF
6
Not used
Do not change the factory setting.
7
Communication
0: Disabled
This is a fault-finding aid. The LCD shows the key parameters
parameter display
1: Enabled
(see below). This is normally disabled because it cancels the
RTI/CSl display for the user.
96
S
2D
AN DCS
10M
Modem rate Resolution Coding Size and reduction
Mode
I/O Rate
96: 9600 bps S: Standard 1D: MH
A: A4 width [8.5”]
DCS: CClTT G3 0M: 0 ms/line
72: 7200 bps D: Detail
2D: MR N: No reduction
NSS: Ricoh G3 5M: 5 ms/line
48: 4800 bps F: Fine
1E: EFC + MH
10M: 10 ms/line
24: 2400 bps
2E: EFC + MR
20M: 20 ms/line
1C: MH + ECM
40M: 40 ms/line
2C: MR + ECM
2-36
To Next Page
Loading...
