Ricoh G-P3 - Page 200

2528
[Thick: [FC]: TE] Transfer roller current and discharge plate voltage correction for the
trailing edge area of thick paper 1 in color mode
Paper Side: 1st or 2nd
2528 003 Separation *EGB
[0 to 400 / 100 / 5%/step]
The value displayed on the LCD is different from
these SP's values. For example, "20%" on the LCD
actually means 100%.
2528 007 T. Roll 2: 1st *EGB
2528 012 T. Roll 2: 2nd *EGB
2531
[Thick2: [K]] Transfer roller current and discharge plate voltage for the image area of
thick paper 2 in B/W mode
Unit -> T.Roll2: Transfer roller, Separa.: Discharge plate (paper separation)
2531 007 Transfer Roller 2 *EGB
Adjusts the transfer roller current.
[0 to 100 / 9.2 / 0.1 -µA /step]
2531 008 Separation *EGB
Adjusts the discharge plate voltage.
[0 to 4 / 2.0 / 0.1 -KV/step]
2536
[Thick2: [FC]] Transfer roller current and discharge plate voltage for the image area of
thick paper 2 in color mode
2536 013 Transfer Roller 2 *EGB
Adjusts the transfer roller current.
[0 to 100 / 12.3 / 0.1 -µA /step]
2536 014 Separation *EGB
Adjusts the discharge plate voltage.
[0 to 4 / 2.0 / 0.1 -KV/step]
2551
[Thick2: [K]: LE] Transfer roller current and discharge plate voltage correction for the
leading edge area of thick paper 2 in B/W mode
2551 003 Separation *EGB [0 to 400 / 100 / 5%/step]
The value displayed on the LCD is different from
these SP's values. For example, "20%" on the LCD
actually means 100%.
2551 007 Transfer Roller2 *EGB
2552
[Switch Timing] Switch timing from leading edge to normal, thick paper 2
(Paper Type, Edge) Paper Type -> TC2: Thick 2, LE: Leading Edge
2552 002 T. Roll 2: TC2: LE *EGB [0 to 200 / 10 / 1 mm/step]
Service Mode Table
199
5