Ricoh G-P3 - Page 335

33 Incorrect SD card version
Incorrect ROM data on the SD card, or data is
corrupted.
34
Module mismatch - Correct module is
not on the SD card)
SD update data is incorrect. Acquire the correct data
(Japan, Overseas, OEM, etc.) then install again.
35
Module mismatch – Module on SD
card is not for this machine
SD update data is incorrect. The data on the SD card
is for another machine. Acquire correct update data
then install again.
36
Cannot write module – Cause other
than E34, E35
SD update data is incorrect. The data on the SD card
is for another machine. Acquire correct update data
then install again.
40 Engine module download failed
Replace the update data for the module on the SD
card and try again, or replace the EGB board.
42
Operation panel module download
failed
Replace the update data for the module on the SD
card and try again, or replace the LCDC.
43 Stamp data module download failed
Replace the update data for the module on the SD
card and try again, or replace the hard disks.
44 Controller module download failed
Replace the update data for the module on the SD
card and tray again, or replace controller board.
50 Electronic confirmation check failed
SD update data is incorrect. The data on the SD card
is for another machine. Acquire correct update data
then install again.
5. Service Tables
334
5