6 4400 (GPS)
7 4500 (PDL)
8 4600 (GPS-PM)
9 2000 (NCS)
10 2224 (BCU)
• The default settings for Keys 1 to 10 are all zero (“0”).
Key to Acronyms
Acronym Meaning Acronym Meaning
ECS Engine Control Service NFA Net File Application
GPS GW Print Service PDL Printer Design Language
GSP-PM GW Print Service – Print Module PTS Print Server
IMH Image Memory Handler SCS System Control Service
MCS Memory Control Service SRM
System Resource
Management
NCS Network Control Service WebDB
Web Document Box
(Document Server)
The machine is now set to record the debugging information automatically on the HDD (the target selected
with SP5857-002) for the events that you selected with SP5858 and the memory modules selected with
SP5859.
Please keep the following important points in mind when you do this setting:
• The initial settings are all zero.
• These settings remain in effect until you change them. Be sure to check all the settings, especially the
settings for Keys 6 to 10. To switch off a key setting, enter a zero for that key.
• You can select any number of keys from 1 to 10 (or all) by entering the corresponding 4-digit numbers
from the table.
• One area of the disk is reserved to store the debug log. The size of this area is limited to 4 MB.
Using the Debug Log
339
To Next Page
Loading...
