• The diagram shows the effect on line skew [B] when you turn the cam in a counter clockwise
direction.
7. Close the left cover. Then measure the skew values again with SP 2111 3. (To do this, repeat step 3.)
• If these are close to the value for magenta that you found in step 1 (within one click in the above
table), go to the next step. If not, do SP 2111 3 again until you get a good result.
8. Do SP 2111 1 to finely adjust the line position for each color.
• Try SP 2111 2 if “Result = OK” does not show.
9. When you get “Result = OK”, this adjustment is completed.
Laser Optics
55
To Next Page
Loading...
