1. Adjust the paper guides to the size of the originals.
2. Place the aligned originals squarely face up and place them all the way straight into
the one-pass duplex scanning ADF.
Place the originals with the first page facing up.
Fan sheets before loading so that multiple originals do not stick to each other and
are not fed at once. If the edge of the paper is not cut well, the edges of the paper
curl back, forming what are called burrs. Before you set originals with burrs, fan the
originals carefully.
Do not stack the originals beyond the limit mark.
• When you place originals that have different widths at the same time (Mixed Sizes),
adjust the original guide to the largest original, and place the smaller originals to
align to the fence on the back side.
To Next Page
Loading...
