• Do not block the sensors with your hand. Be sure to load the originals neatly and
do not push them into the ADF forcibly. It may cause paper misfeeds or paper
size error.
1. Adjust the original guide to the original size.
2. Place the aligned originals squarely face up in the ARDF.
Place the originals with the first page facing up.
Fan sheets before loading so that multiple papers do not stick to each other and are
not fed at once.
Do not stack the originals beyond the limit mark.
• When you place originals that have different widths at the same time
(Mixed Sizes), adjust the original guide to the largest original, and place the
smaller originals to align to the fence on the back side.
To Next Page
Loading...
