Ricoh IM C3510 - Page 110

2. Copy
108
2
If the Readable Orientation Is Not Vertical
When you copy a portrait original larger than A4 or 8
1
/
2
" × 11" (LT) (A3 or 11" ×
17"), place it as shown below, and then specify [Original Orientation].
Place
Orientation
Exposure Glass
Rotate the original
clockwise or
counter-clockwise
90 degrees and
place it face down.
ADF
Rotate the original
clockwise or
counter-clockwise
90 degrees and
place it face up.
When the top position is specified by the staple and punch functions
Place an original as shown below, and then specify [Original Orientation].
Place
Orientation
Exposure glass
Place the original
face down in a
readable
orientation.
ADF
Place the original
face up in a
readable
orientation.
3. Press [Original Orientation] on the Copy screen.
If the key is not displayed, select it from [Original Setting/Store File].
When you place the original face up in a readable orientation, this setting is not
necessary if [Readable Direction] is displayed on the key. Placing of the original is
completed.