Ricoh IM C3510 - Specifying Paper Type and Thickness Settings

1. Introduction and Basic Operations
92
1
8. Press [OK] three times.
9. After completing the configuration, press [Home] ( ).
Specifying Paper Type and Thickness Settings
If the print settings and the loaded paper that are used for a print job do not match, a
mismatch error occurs.
Check and specify the paper settings before you start printing.
• Before you change the settings, confirm the priority of the paper settings for
printing (priority to the printer driver or to the control panel).
[Settings] [Printer Settings] [System] [Paper In/Out] [Tray Setting
Priority]
On the printer driver
Check the settings of paper tray and paper type on the printer driver and make sure
the settings match the loaded paper.
On the control panel
1. Press [Settings] on the Home screen.
2. Press [Tray/Paper Settings].
3. Press [Paper Size/Paper Type].
4. Press one tray to set.