• To scan originals larger than B4 JIS or 8
1
/
2
× 14 size, raise the ADF's
extender on the ADF output tray.
• When using the ARDF to scan originals with a paper weight less than 40.7
g/m
2
(approx. 11 lb. Bond), move the slide tray on the original output tray
to the left side. When the slide tray of the Auto Reversible Document
Feeder (ARDF) is in the left, the amount of output paper will be low. After
scanning a thin original, return the slide tray to the previous position.
Placing Originals in the One-pass Duplex Scanning ADF
• Do not block the sensors with your hand. Be sure to load the originals neatly and
do not push them into the ADF forcibly. It may cause paper misfeeds or paper
size error.
• Do not add originals while other originals are being fed.
• If you want to add the originals to the bottom of the original stack on the ADF,
remove the originals temporarily to add the new originals, and then reload the
combined stack of originals.
To Next Page
Loading...
