2. Select [Scan to Email] on the scanner screen.
3. Place the original on the scanner.
See "Placing an Original to Scan", User Guide (HTML).
4. Press [Send Settings] on the scanner screen.
5. Press [Sender] and specify the sender.
• When a logged in user is operating the machine, the logged in user becomes the
sender.
• When [On] is specified in [System Settings] [Send (Email/Folder)] [Email]
[Auto Specify Sender Name], you can send an e-mail even when the sender
is not specified. The administrator's e-mail address that is registered on the
machine is used as the sender.
• Specify the sender to receive an opening confirmation.
6. Select the [Reception Notice] check box to receive an opening confirmation of the e-
mail from the destination.
7. Specify the destination on the scanner screen.
To Next Page
Loading...
