Common Procedures
J012/J013/J014 3-20 SM
5. Pull the fan connector harness [1] out of its L-clamp.
6. Disconnect the fan harness connector [2] (x1).
7. Remove fan bracket screws [3] and [4] then remove the fan (x2).
8. Raise the latch and remove the right front door sensor [1].
9. Remove the harness [2] of the right front door sensor from the clamps (=x3).
10. Under the right front corner of the inner cover [1] remove the screws (x2).
11. Separate the corner of the inner cover [2] from the top cover [3].
12. Slide the right inner cover forward to remove it.
To Next Page
Loading...
