Common Procedures
SM 3-27 J012/J013/J014
Replacement
Adjustment
9. While still supporting the upright scanner unit, pull the USB harness and ground wire out
[3] out of the machine.
10. At the left rear corner [1], pull the scanner power harness, small harness, and ground
wire out of the machine.
11. Lift the scanner unit off the machine and place it on a flat, clean surface.
To upload address book data to the machine:
Do this procedure after the scanner unit has been replaced.
1. Start the Device Setup Utility.
2. From the "File" menu select "Open.”
3. Navigate to the folder where the address book was stored using the "Download"
command and open the file.
4. In the menu bar click [Tools]> [Upload].
5. Click the [Yes] button to start the uploading the address book data from the file to the
machine.
While the data is uploading to the machine, you will see "*Please Wait* Setting from
PC…" displayed on the printer operation panel.
To Next Page
Loading...
