SC Error Codes
SM 4-39 J012/J013/J014
Trouble-
shooting
Code Possible Cause
004E Received DCN signal after DIS sent in V.34.
0050 No correct signal received after CJ signal sent in V.8 phase.
0051 No phase 3 signal sent after phase 2 within 20 sec. in V.34.
0053 Modem disconnected after phase 4 in V.34.
0054 Remote machine disconnected after phase 4 in V.8
0055 Received incorrect signal after DIS signal sent in V.34
0056 Modem disconnected after CFR sent in V.34.
0058
No image signal detected within 6 sec. after modem entered primary phase in
V.34.
0059 Relay box deleted while relay job was being received.
005A Modem did not detect a correct ECM frame with 3 min. in phase C.
005B No phase 5 signal detected after primary channel within 6 sec.
005C Busy tone detected on control channel after phase C.
005D Modem did not detect a correct ECM frame within 12 sec. in phase C.
005E No control channel signal detected within 6 sec. after RCP frame was received.
005F No silence detected after JM signal was sent during TX polling.
0060 No bulletin files to be polled in V.34.
0061 No V.21 or V.8 signal detected with 35 sec.
0062
Modem disconnected in phase D after local machine sent flag sequence on
control channel.
0063 No flag sequence on control channel within 6 sec. in phase D.
0064
No control channel signal received in phase D within 60 sec. even with power
on the line.
To Next Page
Loading...
