Ricoh J014 - Page 209

SC Error Codes
SM 4-43 J012/J013/J014
Trouble-
shooting
Code Possible Cause
00D2 Received DCN after sending PPS_EOP signal.
00D3 Received DCN after sending PPS_NULL signal.
00D4 Received DCN after sending PPS_EOM signal.
00D8 No correct phase 3 signal detected for polling within 25 sec.
00D9 No correct phase 3 signal detected when silence detected after phase 2.
00DA
No Phase 4 signal detected within 30 sec. or remote machine hung up longer
than 6 sec.
00DB Cannot received any T.30 signal within 15 seconds within phase 4.
00DC T.30 signal received in Phase 4 was signal other than DCS, DIS or DTC.
00DD
Remote machine is not the same model, or no mailbox ID defined for mailbox
TX.
00DE Remote machine has no SUB capability in V34.
00E0 TX unit sent PPS_NULL 3 times at Phase D but received no answer.
00E1 Received incorrect response after sending PPS_NULL.
00E2
No response received during RR response procedure after PPS_NULL was
sent.
00E4 TX unit sent PPS_MPS 3 times at Phase DTX but received no answer.
00E5 Received incorrect response after sending PPS_MPS.
00E6
No response received during RR response procedure after PPS_MPS was
sent.
00E7 Received DCN after sending PPS_MPS.
00E8 TX sent PPS_EOP 3 times at Phase D but received no answer.
00E9 PIN signal received after last page was sent three times.
00EA No RX response received during RR response procedure after PPS_EOP
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA