Service Mode
SM 5-9 J012/J013/J014
Service
Tables
Machine Status Comment
Data RX (USB) V If a job is in progress when you enter
service mode it will complete, a new
transmission cannot start until the
machine leaves service mode.
Print N
Scan Mode Set Original for Scan N
Scan Original N
Send via NIC V If a job is in progress when you enter
service mode it will complete, a new
transmission cannot start until the
machine leaves service mode.
TWAIN USB N
TWAIN NIC N
LSD N
PWM N
To avoid problems, disconnect the USB and network cables before using these
service mode menus. Be sure to advise the operator that USB and network data
transmissions will not be available while the machine is being serviced. Be sure to
reconnect the cables when you are finished.
To Next Page
Loading...
