Important Parts
J012/J013/J014 6-8 SM
7. USB slot
This is the connection point for the USB cable from the PC.
8. Ethernet Port
Connect the Ethernet cable here if the optional NIB is installed. (The NIB is standard for
the J014.)
9. Vent
Vents air from inside the machine to prevent overheating. Never block this vent.
10. Paper feed wheel
Rotate to remove paper that has jammed and wrapped around the guide board.
11. Duplex unit
This is the mechanism that inverts paper for duplex printing (printing on the second
side).
12. Guide board
Open to remove paper jammed in the machine.
13. G3 (analog) line interface connector
This is the connection point for a telephone line.
14. External telephone connector
This is the connection point for an extension telephone.
To Next Page
Loading...
