Using the Operation Panel
SM 1-9 J012/J013/J014
Installation
select the symbol that you want to enter.
To enter text
The number keys are used to enter text. Enter text with "[A]" on the operation panel
display.
5. If "[1]" is on the display, press [&] to change it to "[A].”
6. Press the appropriate number key (see table below).
7. ['] or [(] the letter to enter then press the same number key again.
8. To delete a letter, move the cursor ['] or [(] to the letter to delete then press [No]. This
deletes the letter at the cursor position.
To Next Page
Loading...
