Scanner Problems
When You Cannot Browse the Network to Send a Scan File
Problem Solution
The following machine settings may
not be correct:
• IP address
• Subnet Mask
Check the settings. See page 293 "Configuring the Network
Settings".
When Scanning Is Not Done As Expected
Problem Solution
The machine does not start scanning. The ADF or its cover is open. Close the ADF or its cover.
The scanned image is dirty. • The exposure glass or ADF is dirty. See page 313
"Maintaining the Machine".
• Before placing originals on the exposure glass, make
sure that toner or correction fluid is dry.
The scanned image is distorted or
out of position.
The original was moved during scanning. Do not move the
original during scanning.
The scanned image is upside down. The original was placed upside down. Place the original in the
correct orientation. See page 76 "Placing Originals".
The scanned image is blank. The original was placed with the front and back reversed.
When using the exposure glass, place originals copy side
down. When using the ADF, place originals copy side up. See
page 76 "Placing Originals".
The scanned image is too dark or
too light.
Adjust the image density. See page 167 "Specifying Scan
Settings for Scanning".
10. Troubleshooting
378
To Next Page
Loading...
