Ricoh M C250FW - Connecting to a Wireless Network

11. Configuring Network Settings
This chapter describes how to connect the machine to the network and specify the network settings.
Configurations differ according to the communication environment of your system.
Connecting the Machine to a Wired Network
Configuring the IPv4 Setting
1. Press the [Setting] icon on the [Home] screen.
2. Press [Network Settings].
3. If you are requested to enter a password, enter the password using the number keys,
and then press [OK].
You can display the software keyboard by double tapping the entry area on the display.
A password for accessing the [Network Settings] menu can be specified in [Admin. Tools Lock]
under [Administrator Tools] menu.
4. Press [IPV4 Configuration].
5. Press [IPV4 DHCP].
6. Select [Active] to automatically obtain the IP address or [Inactive] to specify the IP
address manually.
If you have selected [Active], proceed to Step 11.
7. Enter the machine's IPv4 address in [IP Address].
8. Enter the subnet mask in [Subnet Mask].
9. Enter the gateway address in [Gateway Address].
10. Press [OK].
11. Turn off the machine, and then turn it back on.
Setup is completed.
Configuring the IPv6 setting
1. Press the [Setting] icon on the [Home] screen.
2. Press [Network Settings].
3. If you are requested to enter a password, enter the password using the number keys,
and then press [OK].
You can display the software keyboard by double tapping the entry area on the display.
391