*4
Enter the paper size. For copier mode, see "Copying onto Custom Size Paper from the Bypass Tray",
Copy/ Document Server. For printer mode, see page 126 "Specifying a custom size paper using the
control panel".
*5
When loading Translucent paper in the bypass tray, do not stack paper over the limit mark.
*6
When loading OHP transparencies in the bypass tray, do not stack paper over the limit mark.
*7
Load envelopes so that the height of the stack of envelopes does not exceed the limit mark of the bypass
tray without pressing on the stack of envelopes.
Paper Thickness
Paper Thickness
*1
Paper weight
Thin Paper 52–65 g/m
2
(14–18 lb. Bond)
Plain Paper 66–74 g/m
2
(18–20 lb. Bond)
Plain Paper 2 75–90 g/m
2
(20–24 lb. Bond)
Middle Thick 91–105 g/m
2
(24–28 lb. Bond)
Thick Paper 1 106–130 g/m
2
(28–35 lb. Bond)
Thick Paper 2 131–162 g/m
2
(35 lb. Bond–90 lb. Index)
*1
Print quality will decrease if the paper you are using is close to the minimum or maximum weight.
Change the paper weight setting to thinner or thicker.
• Recommended paper: Paper with calcium carbonate (CaCO3) ratio of 15% or less.
• Certain types of paper, such as translucent paper or OHP transparencies, may produce noise
when delivered. This noise does not indicate a problem and print quality is unaffected.
• The paper capacity described in the tables above is an example. Actual paper capacity might be
lower, depending on the paper type.
• When loading paper, make sure the stack height does not exceed the limit mark of the paper tray.
• If multiple sheet feeding occurs, fan sheets thoroughly or load sheets one by one from the bypass
tray.
• Flatten out curled sheets before loading them.
• Depending on the paper sizes and types, the copy/print speed may be slower than usual.
• When loading envelopes, see "Loading Envelopes", Paper Specifications and Adding Paper.
• When loading thick paper of 106–162 g/m
2
(28 lb. Bond–90 lb. Cover), see page 148 "Thick
paper".
Recommended Paper
147
To Next Page
Loading...
