Message Cause Solution
"The program is recalled.
Cannot recall the folder
destination(s) with protection
code(s)."
The folder destinations for
which the protection code
was set were registered in
the program.
A destination for which the protection
code is set cannot be recalled by the
program. Cancel the protection code
setting or send scanned files to the
destination separately.
When documents cannot be scanned properly
Message Cause Solution
"All the pages are detected
as blank. No file was
created."
No PDF file was created
because all the pages of the
scanned original were
detected as blank when
[On] is specified for [Delete
Blank Page] in [OCR
Settings].
Check whether the original is set
upside down.
Change [OCR Scanned PDF: Blank
Page Sensitivity] in [Scanner Features]
to "Sensitivity Level 1".
"Check original's
orientation."
Originals may sometimes not
be scanned depending on a
combination of items such as
the specified scaling factor
and document size.
Change the orientation of the original,
and then scan the original again.
"Exceeded max. data
capacity."
"Check scanning resolution,
then press Start key again."
The scanned data exceeded
maximum data capacity.
Specify the scan size and resolution
again. Note that it may not be possible
to scan very large originals at a high
resolution. For details about the settings
for the scanner function, see
"Relationship between Resolution and
Scan Size", Scan.
"Exceeded max. data
capacity."
"Check the scanning
resolution, then reset n
original(s)."
("n" in the message
represents a variable.)
The scanned original
exceeded maximum data
capacity.
Specify the scan size and resolution
again. Note that it may not be possible
to scan very large originals at a high
resolution. For details about the settings
for the scanner function, see
"Relationship between Resolution and
Scan Size", Scan.
10. Troubleshooting
192
To Next Page
Loading...
