Ricoh Network Guide - Web; Wiconfig

Remote Maintenance by telnet
107
4
web
Use the “web” command to display
and configure parameters on Web
Image Monitor.
❖
❖❖
❖ View Settings
msh> web
❖
❖❖
❖ URL Configuration
You can set URLs linked by click-
ing [URL] on Web Image Monitor.
Specify "1" or "2" for x as the
number corresponding to the URL.
Up to two URLs can be registered
and specified.
msh> web url http://”The
URL or IP address you want
to register”/
❖
❖❖
❖ Deleting URLs registered as link des-
tinations
msh> web x clear url
Specify "1" or "2" for x as the corre-
sponding number to the URL.
❖
❖❖
❖ Link name configuration
You can enter the name for [URL] that
appears on Web Image Monitor.
Specify "1" or "2" for x as the corre-
sponding number to the link name.
msh> web name “Name you
want to display”
❖
❖❖
❖ Deleting URL names registered as
link destinations
msh> web x clear name
Specify "1" or "2" for x as the number
corresponding to the link name.
❖
❖❖
❖ Help URL Configuration
You can set URLs linked by click-
ing [Help] or [?] on Web Image
Monitor.
msh> web help http://”Help
URL or IP address”/help/
❖
❖❖
❖ Deleting Help URL
msh> web clear help
wiconfig
Use the "wiconfig" command to make
settings for IEEE 802.11b.
❖
❖❖
❖ View settings
msh> wiconfig
❖
❖❖
❖ View IEEE 802.11b settings
msh> wiconfig cardinfo
• If IEEE 802.11b is not working
correctly, its information is not
displayed.
❖
❖❖
❖ Configuration
msh> wiconfig “parameter”
Parameter Value configured
mode {ap|ad-
hoc|802.11adhoc}
You can set the in-
frastructure mode
(ap) , the 802.11 Ad
hoc mode
(802.11adhoc), or
the ad hoc mode
(adhoc).
The default is ad
hoc mode.
ssid “ID value” You can make set-
tings for the SSID
in the infrastruc-
ture mode.
Usable characters
are ASCII 0x20-
0x7e (32 bytes).
An SSID value is
set automatically
to the nearest ac-
cess point if no set-
ting is made.
If no setting is
made for the ad
hoc mode, the
same value as for
the infrastructure
mode or an ASSID
value is automati-
cally set.