Monitoring and Configuring the Printer
90
4
autonet
Use the “autonet” command to con-
figure AutoNet parameters.
❖
❖❖
❖ View settings
The following command displays
the current AutoNet settings:
msh> autonet
❖
❖❖
❖ Configuration
You can configure AutoNet settings.
msh> autonet {on|off}
• {on} means "active" and {off}
means "inactive".
❖
❖❖
❖ Current interface priority configura-
tion display
msh> autonet priority
❖
❖❖
❖ Interface priority configuration
msh> autonet priority
“interface_name”
• You can give interface's Au-
toNet parameter priority.
• Priority settings are available
when multiple interfaces are in-
stalled.
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
• wlan can be specified only when
the IEEE 802.11b interface is in-
stalled.
Note
❒ If an interface is not selected, the
current interface connection set-
tings remain in effect.
btconfig
Use the "btconfig" command to make
Bluetooth settings.
❖
❖❖
❖ View settings
Bluetooth settings are displayed.
msh> btconfig
❖
❖❖
❖ Mode settings
You can set the Bluetooth opera-
tion mode to {private} or {public}.
msh> btconfig {private |
public}
• The default is {public}.
devicename
Use the "devicename" command to
display and change the printer name.
❖
❖❖
❖ View settings
msh> devicename
❖
❖❖
❖ Printer name configuration
msh> devicename name
“string”
• Enter a printer name using up
to 31 alphanumeric characters.
• Set single names for each print-
er.
❖
❖❖
❖ Printer name initialization
msh> devicename clear name
• Reset the printer name to its de-
fault.
Interface name Interface config-
ured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan IEEE 802.11b inter-
face
To Next Page
Loading...
