Monitoring and Configuring the Printer
130
4
pserver start. (NetWare) (In the print server mode) The NetWare serv-
ice has started.
Required computer name (<Computer
name>) is duplicated name
The start job found the computer name by
adding the computer name to the suffix (0,1...).
Set a new computer name that is unique.
Required file server (<file server name>) not
found
The required file server is not found.
restarted. The lpd service has started.
sap enable, saptype=<SAP type>, sap-
name=<SAP name>
The SAP function has started. The SAP packet
is issued to advertise the service on the SAP ta-
ble on the NetWare server.
session <community name> already defined. The requested community name is not de-
fined.
session_ipx <community name> not defined. The requested community name is not de-
fined.
Set context to <NDS context name> An NDS context name has been set.
shutdown signal received. network service re-
booting...
The network service is rebooting.
smbd start. (NetBEUI) The smbd service has started.
SMTPC: failed to get smtp server ip-address. The SMTP server IP address could not be ob-
tained. This could be because:
• The specified DNS server could not be
found.
• No connection to the network has been es-
tablished.
• The specified DNS server could not be
found.
• An incorrect DNS server is specified.
• The specified SMTP server IP address
could not be found in the DNS server.
SMTPC: failed to connect smtp server. time-
out.
Connection to the SMTP server failed due to
timeout. This could be because:
• The specified SMTP server name is incor-
rect.
• No connection to the network has been es-
tablished.
• The network configuration is incorrect, so
there is no response from the SMTP server.
SMTPC: refused connect by smtp server. Connection to the SMTP server is denied. This
could be because:
• A server other than the SMTP server has
been specified.
• The specified SMTP server port number is
incorrect.
Message Problem and solutions
To Next Page
Loading...
