99
Appendix
6
The focus
cannot be
locked.
AF Mode of Live View
is set to f (Tracking).
Set [Contrast AF] to e, g, h
or i. (p.46)
The camera is
not recognized
when it is
connected to a
computer.
The USB connection
mode is set to [PTP].
Set [USB Connection] to [MSC]
in the D2 menu. (w p.R30)
Dust or dirt
particles appear
in images.
The CMOS sensor is
dirty or dusty.
Activate [Dust Removal]
from the D4 menu. The Dust
Removal function can be
activated every time the camera
is turned on and off. (w p.R37)
Refer to “Sensor Cleaning” if the
problem persists. (w p.R37)
There are pixels
in the monitor or
captured images
that do not light
up or remain lit.
There are defective
pixels in the CMOS
sensor.
Activate [Pixel Mapping] from
the D4 menu. (w p.R35)
It takes about 30 seconds to
correct the defective pixels, so
be sure to install a fully charged
battery.
Problem Cause Remedy
e_kb547_ENG.book Page 99 Thursday, May 15, 2014 9:35 AM
To Next Page
Loading...
