47
Shooting Functions
3
Exposure Setting
1 Turn the metering mode
switching dial.
The set metering mode is displayed
on the status screen, Live View
screen and in the viewfinder.
Memo
• You can link the metering point and the AF point. Set in [5. Link AE
and AF Point] of the E1 menu. (w p.R39)
You can set the sensitivity to [AUTO] or a value in the range
equivalent to ISO 100 to 204800 (ISO 100 to 3200 for C
mode).
1 Turn R while pressing N.
Press M while pressing N to switch
to [AUTO].
Memo
• Set the range of automatic sensitivity adjustment with [ISO AUTO
Setting] in the A2 menu or on the control panel. (w p.R17)
• You can set the sensitivity in increments of 1 EV or in accordance
with the EV Steps setting for exposure. Set from [2. Sensitivity
Steps] of the E1 menu. (w p.R39)
• You can reduce noise at high sensitivity with [High-ISO NR]
in the A2 menu or on the control panel. (w p.R17)
• The framerate for Continuous Shooting may slow down when
the sensitivity is high.
Selecting the Metering Mode
A
Multi-
segment
Meters the brightness in multiple different zones
of the sensor.
In backlit locations, this mode automatically adjusts
exposure.
B
Center-
weighted
Meters the brightness with an emphasis on the
center of the sensor.
The sensitivity increases at the center and no
automatic adjustment is performed even in backlit
conditions.
C
Spot
Meters the brightness only within a limited area
at the center of the sensor.
Useful when the subject is small.
Exposure Metering Timer
Set the exposure metering time with [3. Meter Operating Time]
of the E1 menu. (w p.R39)
Setting the Sensitivity
e_kb547_ENG.book Page 47 Thursday, May 15, 2014 9:35 AM
To Next Page
Loading...
