R23
Rec. Mode Menu
A
Memo
• The settings saved as the USER mode can be displayed on
the monitor when you select [Check Saved Settings] in Step 3.
• To reset the settings to the default values, select [Reset USER
Mode] in Step 3.
You can change the name of the USER mode in which you
saved settings.
1 Select [Rename USER Mode] in Step 3 of “Save
Settings” and press D.
The [Rename USER Mode] screen appears.
2 Select [USER1], [USER2] or [USER3], and press D.
The text-entry screen appears.
3 Change the text.
Up to 18 single-byte alphanumeric
characters and symbols can be
entered.
Available operations
4 After entering the text, move the text selection cursor
to [Finish], and press E.
The [Rename USER Mode] screen reappears.
1 Set the mode dial to O, P or Q .
The USER mode guide is displayed for
30 seconds.
Use AB to check the saved settings.
2 Change the settings as necessary.
The exposure mode can be changed in
[Exposure Mode] of the A1 menu.
Memo
• The settings changed in Step 2 are not saved as the USER mode
settings. When the camera is turned off, the settings return to the
originally saved ones. To change the original settings, save the
USER mode settings again.
Rename USER Mode
ABCD
Moves the text selection cursor.
R
Moves the text input cursor.
J
Switches between upper and lower case letters.
E
Enters a character selected with the text selection
cursor at the position of the text input cursor.
L
Deletes a character at the position of the text input cursor.
To Next Page
Loading...
