HOW TO USE IMAGE MAKE-UP MODE
Outline Mode (One Command Sheet)
Press the Make-up key.
If you want to leave the Make-up
mode at any time, press the Make-
up key again.
Using the Number key, select
the Outline mode (Fn2) for the
designated area. (* See page
5.)
Press the Enter key.
If a Fn No. (Command number)
was entered previously and is still
in memory, press the Clear key.
The commands entered previously
are stored in memory until the
main switch is turned off or the
Clear Modes key is pressed.
Press the Enter key again.
17
To Next Page
Loading...
